Contact Us
- Building 21, Cuigang Industrial Park, Fuyong Street, Baoan District, Shenzhen, 518000, China
- cherry@hengtaijd.com
- +8613715330926
-
20/Feb
2024
Turning parts - boring holes
Boring hardened materials requires a large cutting pressure, so it is often necessary to multiply the torque and tangential force borne by the boring bar. Using a positive rake ang
-
19/Feb
2024
Turning parts - process
Because most of the heat generated by hard turning is carried away by the chips, checking the chips before and after processing can reveal whether the entire process is coordinated
-
18/Feb
2024
Turning parts - blades
Although cubic boron nitride (CBN) blades are expensive, CBN blades are most suitable for hard turning. CBN blades can maintain their positioning during intermittent cutting and pr
-
17/Feb
2024
Solution to Rough Surface of Thread in Turning Parts
Fault analysis and solution: The reason is that the cutting edge of the turning tool is not polished smoothly, the cutting fluid is not appropriate, the cutting speed and workpiece
-
16/Feb
2024
Solution to incorrect center diameter of turning parts
Fault analysis and solution: The reason is that the cutting tool is too large, the dial is not accurate, and the measurement is not done in a timely manner. The solution is to care
-
15/Feb
2024
Digital Collection of Weldments
Module divided into image acquisition control module In order to achieve the calculation of weld seam size and defect rating on the surface of welded parts, it is first necessary t
-
14/Feb
2024
Hardware System Design of Weldments
The weld appearance inspection system needs to obtain digital images of the surface of the weld, so the image acquisition of the system needs to be based on hardware. At the same t
-
13/Feb
2024
Analysis of Welding Component Requirements
Based on the characteristics of measuring the appearance dimensions and defect distribution of welded parts, the welding appearance inspection system mainly achieves the following
-
12/Feb
2024
Welding method of welded parts
Welding methods are divided into four types: flat welding, vertical welding, horizontal welding, and overhead welding. Different welding methods should be selected based on the str
-
11/Feb
2024
Welding joint form
There are four types of welding joints: butt joints, T-joints, corner joints, and lap joints. The size of the butt joint of the welded workpiece is determined by the joint form, th
-
10/Feb
2024
Introduction to Welding Components
With the acceleration of modern industrial processes, conventional inspection methods for welding surface are no longer able to meet the requirements of industrial production. Ther
-
09/Feb
2024
What is a welded component
There are four types of welding joints: butt joints, T-joints, corner joints, and lap joints. The size of the butt joint of the welded workpiece is determined by the joint form, th